Servo End Point Adjuster
£12.50 inc. VAT
FREE DELIVERY
PRODUCT DESCRIPTION
The All in One Glow Switch has been designed as a complete ready to use glow switch. The unit is fitted with a built in 1800ma NiCad and uses a croc clip to go onto the tip of the glow plug and a tag washer to go under one of the engine bolt.
The charging of the internal cell is done by using a standard radio charger.
INSTRUCTIONS FOR USE
Plug your servo into the flying lead on the End Point Unit. Plug the other End Point Unit lead into the selected channel on the receiver. The servo will operate with full travel.
The End Point Unit has two input keys, the increase key and the decrease key. The neutral position can be set and end point positions between 20% and 100% travel can be individually set each side of neutral.
NEUTRAL SET-UP
With the stick at neutral, use the increase or decrease keys to move the servo neutral to the required position. The servo will move one step each time the key is released. The neutral can be adjusted over a range of about 10% of travel. Note that the neutral position affects the end point positions so it is advisable to set the neutral first.
END POINT SET-UP
To enter the end point set-up, press both keys simultaneously for about 1 second. The LED will light to indicate that the end point set-up procedure is active. Release the keys.
Move the transmitter stick to its full movement on one side of neutral. While holding it there, press the decrease key. The servo travel end point will reduce. Pressing the increase key will cause the travel to increase. Use the increase and decrease keys to move the servo to the required end point position.
Repeat this procedure with the transmitter stick to its full travel on the other side of neutral.
Move the transmitter stick from side to side to confirm the correct end point positions.
When you are satisfied that the correct settings have been achieved, press and release both keys simultaneously to exit the set-up. Do not hold the keys too long or the system will once again enter set-up. The LED will extinguish to confirm that the operational mode is selected. THE NEW SETTINGS WILL NOT BE STORED UNLESS THE SET-UP IS EXITED.
If you wish to change the set points at any time, simply repeat the set-up procedure.
SAFETY
Please ensure that the selection key cannot be pressed accidentally while the unit is in use.
WIRING
Connect the glow battery and glow clip to the Digital Slow Driver following the diagram below. Charging the Nicad Charging the single cell inside the All In One is carried out by plugging into the D.C socket (which is positive centre) with a automatic charge like a Supernova or something similar that can charge a single cell, it is advisable that the charge rate is no more than 2 amps.
