All In One Glow Switch
£32.50 inc. VAT
FREE DELIVERY
PRODUCT DESCRIPTION
The All in One Glow Switch has been designed as a complete ready to use glow switch. The unit is fitted with a built in 1800ma NiCad and uses a croc clip to go onto the tip of the glow plug and a tag washer to go under one of the engine bolt.
The charging of the internal cell is done by using a standard radio charger.
FEATURES
*Push button Set point.
*Automatically detects stick direction. (No reverse switch is needed).
*LED lights when Slow plug is active.
INSTRUCTIONS FOR USE
Connect the throttle servo to the receiver using a "Y" harness and plug the Digital Slow Switch lead into the spare arm of the "Y". Move the throttle stick to the position where you would like the Slow Plug to activate. (About one eighth throttle is a good starting point.) Press the "+" key for about 1 second to store the set point. The tell-tale LED glows to confirm that the set point has been stored. Release the key. If the LED is already glowing (because of a previous setting), when the key is pressed the LED will blink out before glowing to confirm the setting. The set point can be adjusted at any time by repeating the set-up instructions above. When the throttle stick is on full, the tell-tale LED is dark and the glow plug is off. As the throttle stick position is reduced to below the set point, the LED will glow to confirm that the Slow Plug is on.
SET-UP
Connect the throttle servo to the receiver using a "Y" harness and plug the Slow Driver Unit lead into the spare arm of the "Y". Move the throttle stick to the position where you would like the glow plug to activate. (About one eighth throttle is a good starting point.) Press and hold the button until the LED lights up, then release the "Set Point" button to store the set point.
SAFETY
Please ensure that the selection key cannot be pressed accidentally while the unit is in use.
WIRING
Connect the glow battery and glow clip to the Digital Slow Driver following the diagram below. Charging the Nicad Charging the single cell inside the All In One is carried out by plugging into the D.C socket (which is positive centre) with a automatic charge like a Supernova or something similar that can charge a single cell, it is advisable that the charge rate is no more than 2 amps.
