The Standard Glow switch has been designed to switch 1 or 2 glow plugs. The new version uses a one button set system, so setting the switch point and direction is very easy.

The customer fits their own NiCad cells according to number of plugs used 1 cell for one plug and 3 cells for a 2 plug set-up.

The Servo Reverser has been design for situations where you are forced to use a "Y" lead, e.g for ailerons where the second servo is going in the wrong direction.

The reverser is fitted with a button that allows you to adjust the neutral to match the neutral of the first servo.

The standard Relay Switch has been designed to allow RC modellers to switch ancillary electrical devices like lights a camera or flares.

The contacts can handle up to 20 Amps and voltages up to 20 Volts.

The All in One Glow Switch has been designed as a complete ready to use glow switch. The unit is fitted with a built in 1800ma NiCad and uses a croc clip to go onto the tip of the glow plug and a tag washer to go under one of the engine bolt.

The charging of the internal cell is done by using a standard radio charger.

The Deluxe Glow is the same as the standard glow switch, but with all the leads, croc clip, and tag washer fitted. This makes it ready to use apart from fitting the NiCad of your choice to the Glow switch.

This version of the Glow Switch also has a charge socket fitted which you mount on the fuselage for ease of charging.

The End Point Adjuster has been designed mainly for Futaba users with a 9C who want to use the ninth channel for retracts and then find that the transmitter has no travel adjustment to setup the movement of the servo being used.

The end point adjuster gives you this facility and also allows you to reverse the action of the servo and move the neutral point, which means it could also be used in a "Y" situation on aileron.

The Glow Switch lead set has been designed to go with the standard glow switch. This loom makes it easy for people who find it difficult to work out wiring or don't have to time make the loom.

The lead set comes complete with a D.C charging socket. The loom has a croc clip for the plug and a tag washer to connect to the engine the same as the All in One Glow Switch unit.

The Dual Relay Controller is similar to the one above but allows modellers to switch two items on and off (max current 1 amp).

This unit also allows you to use it in a latching or non latching mode on either relay independently of each other.

This Single relay Controller has been designed to allow modellers to switch one item on and off (max current 1 amp).

The unit also allows the user to select latching or non latching mode, so in latching once switched on it stays on until you trigger it to un-latch.

The Servo Tester has 3 modes of operation- manual, auto and step.

It produces a precise signal of 1 to 2ms and exact neutral of 1.5ms, ideal for checking servo installations without radio.

The Servo Tester has 3 modes of operation- manual, auto and step.

It produces a precise signal of 1 to 2ms and exact neutral of 1.5ms, ideal for checking servo installations without radio.

The Servo Travel Expander has been designed to allow a standard servo to travel up to 180 degrees when using a normal 100% set on the transmitter.

This unit can be used with retracts or on the nose wheel steering on a model aircraft or could be used in many other modelling application.

The servo slow has been designed for use with retracts in model aircraft or slowing down flaps, but it could be used in other applications. The delay is adjustable for 1 to 15 seconds.